Aphipar-M

converts into a leathery mummy. The adult parasitic wasp emerges through a hole at the rear of the mummy. The first mummies are noticed in the crop around 10-14 [...] sure the material remains dry and is not moved from its introduction site for at least a few days Dosage The dosage of Aphipar-M depends on climate, crop and [...] typically range from 0.25-4 per m 2 /release. Releases should be repeated at least 3 times. Consult a Koppert advisor or a recognized distributor of Koppert

Aphipar

converts into a leathery mummy. The adult parasitic wasp emerges through a hole at the rear of the mummy. The first mummies are noticed in the crop around 10-14 [...] sure the material remains dry and is not moved from its introduction site for at least a few days Dosage The dosage of Aphipar depends on climate, crop and [...] typically range from 0.25-4 per m 2 /release. Releases should be repeated at least 3 times. Consult a Koppert advisor or a recognized distributor of Koppert

Encarsia formosa

parasitic wasp Encarsia formosa is most effective at temperatures between 20°C and 25°C (68 and 77°F). At a 24 hours average temperature below 17°C/63°F the [...] whitefly ( Bemisia tabaci ) The parasitic wasp Encarsia formosa is available at Koppert as En-Strip . Encarsia formosa products En-Strip Enermix Expand all [...] if possible approximately 75 cm under the plant head Avoid to hang cards at places exposed to direct sunlight The dosage of En-Strip or Enermix depends

Anso-Mite

typically range from 50-250 per m 2 /release. Releases should be repeated at least 3 times at weekly intervals or until control is achieved. Consult a Koppert advisor [...] Carefully sprinkle on the leaves Make sure the material remains on the leaves for at least a few hours after releasing the predatory mites Can also be applied [...] your situation. Environmental conditions Amblyseius andersoni is effective at temperatures above 14°C/57°F. Optimum temperatures are between 20 and 28°C

Orius insidiosus

Apply in groups of at least 50 insects in order to establish a population and encourage mating Make sure the material remains undisturbed at the introduction [...] when using this biocontrol agent by observing their unique characteristics at each stage: Egg stage : Orius insidiosus eggs are small, oval-shaped, and [...] with white markings on their wings. The wings lie flat over their backs when at rest, displaying a characteristic black and white pattern. Adults are active

Capyphor

from the box and keep them at room temperature for 30 minutes Empty the contents of the sachets into a bucket containing at least six litres (1.5 gallons) [...] required amount of water If tank-mixing with a compatible product, add Capyphor at the end to a fully-filled tank Apply directly after preparation of the spray [...] pressure of 20 bar/290 psi (on nozzle) The spray nozzle opening should be at least 0.5 mm (500 microns – 35 mesh) - preferably high flow rate cone nozzle

Grey mould

irrigation water) and nutrients for germination. Germination also happens at very high relative humidity (RH > 93%) on dry plants. The germ tube grows [...] maintain a higher RH once stem infection is present, since more plants die at lower RH remove aborting fruits, since these can be infected after abortion

Swirski Ulti-Mite

Amblyseius swirskii is most effective at temperatures between 20 and 32°C (68 and 90°F). It is not effective at temperatures below 18°C/64°F. Amblyseius [...] sunlight Sachets already have an exit hole Hold sachets by the cardboard strip at the top, to avoid damaging the predatory mites Dosage The dosage of Swirski [...] preventively or as soon as the first pest mites are detected in the crop. Use at least 4,000 sachets per ha and hang them evenly spaced in the crop. Release

Thripex-V

the material remains on the introduction site for at least a few hours after introduction Choose at least 4,000 introduction points per hectare, evenly [...] Neoseiulus cucumeris is most effective at temperatures between 15 and 25°C (59 and 77°F). It is not effective at temperatures above 30°C/86°F. Neoseiulus

Neoseiulus californicus

typically range from 25-125 per m2/release. Releases should be repeated at least five times at weekly intervals. Consult a Koppert advisor or a recognized distributor [...] for use of Neoseiulus californicus Neoseiulus californicus is most effective at temperatures between 13 and 32°C (55 and 90°F) and is sensitive to relative [...] sprinkle material on leaves Make sure the material remains on the leaves for at least a few hours after introduction Can also be applied with (Mini)-Air(o)bug